This is for everybody looking to buy a EBAY laser. You can also disable any given layer there if you only want to one one or a few.
Double click any of those lines to change the parameters. You will likely see layers sorted out with cut or engrave parameters available. It should say something about the laser being on, and then put you into the software for the laser with your drawing loaded. Make sure your laser is on and then click the icon above. If so you can doc it in your tool bar with a click and drag and then drop it where you want it on the bars. Hit OK and then look for the icon up on your toolbar. Look for VBA and open that, then check Trust All installed GMS modules. Install it as administrator on your machine.
You dont say what version of Corel you are using? But this may help for the last few suite versions. Basically it is calling an outside program. This appears to be a recent version in English.Ĭorel Laser is a plug in to Corel and allows you to send data to your laser from within Corel.
0 kommentar(er)
